Powering Up And Configuring The Server - HP PROLIANT DL380 User Manual

62 HP ProLiant DL380 Generation 3 Server User Guide

Powering Up and Configuring the Server

To power up the server, press the Power On/Standby button.
While the server boots, RBSU and the ORCA utility are automatically
configured to prepare the server for operating system installation. To configure
these utilities manually:
•
•
For more information on the automatic configuration, refer to the HP ROM-
Based Setup Utility User Guide located on the Documentation CD.
WARNING: To reduce the risk of electric shock or damage
to the equipment:
• Do not disable the power cord grounding plug. The grounding
plug is an important safety feature.
• Plug the power cord into a grounded (earthed) electric outlet
that is easily accessible at all times.
• Unplug the power cord from the power supply to disconnect
power to the equipment.
• Do not route the power cord where it can be walked on or
pinched by items placed against it. Pay particular attention to
the plug, electric outlet, and the point where the cord extends
from the server.
Press the F8 key when prompted during the array controller initialization to
configure the array controller using ORCA. The array controller defaults to
RAID 0 with one drive installed and RAID 1 with more than one drive
installed.
Press the F9 key when prompted during the boot process to change the server
settings, such as the settings for language and operating system, using RBSU.
The system is set up by default for the English language and a Microsoft
Windows 2000 installation.