Boot Options - HP PROLIANT DL380 User Manual

Drives Installed
1
2
3, 4, 5, or 6
More than 6
NOTE: If the boot drive is not empty or has been written to in
the past, ORCA does not automatically configure the array. You
must run ORCA to configure the array settings.
To change any ORCA default settings and override the auto-configuration
process, press the F8 key when prompted.
By default, the auto-configuration process configures the system for a Microsoft
Windows 2000 operating system and the English language. To change any
default settings in the auto-configuration process, such as the settings for
language, operating system, and primary boot controller, execute RBSU by
pressing the F9 key when prompted. After the settings are selected, exit RBSU
and allow the server to reboot automatically.
For more information, refer to the HP ROM-Based Setup Utility Guide on the
Documentation CD or the white paper on the HP website
(ftp://ftp.compaq.com/pub/products/servers/management/rbsu-whitepaper.pdf).

Boot Options

After the auto-configuration process completes, or after the server reboots upon
exit from RBSU, the POST sequence runs, and then the boot option screen is
displayed. This screen is visible for several seconds before the system attempts to
boot from either a diskette, CD, or hard drive. During this time, the menu on the
screen allows you to install an operating system or make changes to the server
configuration in RBSU.
NOTE: The server may not support all of the following examples.
Drives Used
1
2
3, 4, 5, or 6
0
Server Configuration and Utilities
RAID Level
RAID 0
RAID 1
RAID 5
None
117