HP PROLIANT DL380 User Manual page 86

86 HP ProLiant DL380 Generation 3 Server User Guide
5. Connect the power cord to the power supply.
6. Route the power cord through the cable management arm or power cord
7. Lock the cable management arm into the operating position.
8. Connect the power cord to the power source.
9. Be sure that the power supply LED is green ("Rear Panel LEDs and Buttons"
10. Be sure that the front panel external health LED is green ("Front Panel LEDs
anchor.
NOTE: If using the power cord anchor, be sure to leave enough slack
in the power cord so that the redundant power supply can be removed
without disconnecting the power cord from the primary power supply.
on page 15).
and Buttons" on page 11).