KitchenAid KDRS807XSP00 Installation Instructions Manual page 5

• The flooranti-tip bracket must b einstalled. Toinstall theanti-
tipbracket shipped w iththerange, see"Install Anti-Tip
Bracket" section.
• Grounded electrical supply isrequired. See "Electrical
Requirements" section.
• Proper gas supply connection must b eavailable. See "Gas
Supply R equirements" section.
• Contact aqualified floorcovering installer tocheck t hatthe
floorcovering canwithstand atleast 2 00°F ( 93°C).
• Use aninsulated pador1¼,, (0.64 cm)plywood under range if
installing range o ver c arpeting.
IMPORTANT: Toavoid damage toyour c abinets, check w ithyour
builder orcabinet supplier tomake sure thatthematerials used
will n otdiscolor, delaminate orsustain o ther d amage. This oven
hasbeen designed inaccordance withtherequirements ofUL
andCSA International and complies withthemaximum a llowable
wood cabinet temperatures of194°F ( 90°C).
Mobile Home - Additional Installation Requirements
The installation of this range must conform to the Manufactured
Home Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD Part 280). When such standard is not
applicable, use the Standard for Manufactured Home
Installations, ANSI A225.1/NFPA 501A or with local codes.
In Canada, the installation of this range must conform with the
current standards CAN/CSA-A240-1atest edition, or with local
codes.
Mobile home installations require:
• When this range is installed in a mobile home, it must be
secured to the floor during transit. Any method of securing
the range is adequate as long as it conforms to the standards
listed above.
• Four-wire power supply cord or cable must be used in a
mobile home installation. The appliance wiring will need to be
revised. See "Electrical Connection" section.
Product Dimensions
Freestanding Range Slide-in Range
A
B
A
A. 53/4 '' (14.6 cm)
B. 30" (76.2 cm)
C. 413/4'' (106.0 cm) overafl height
with leveling legs screwed all
the way in. *
D. 36" (91.4 cm) cooktop trim
height with leveling legs
screwed aft the way in*
E. Model/serial number pla te
(located on the right-hand
side oven door trim)
F. 27¼" (69.2 cm) max. from
handle to standoff at back
of range**
*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
**When installed in a 24" (61.0 cm) base cabinet with 25"
(63.5 cm) countertop; front of oven door protrudes 1" (2.5 cm)
beyond 24" (61.0 cm) base cabinet.
A. 309/16 '' (77.6 cm)
B. 35%" (90.5 cm) height to
underside of cooktop edge
with levering legs screwed
all the way in*
C. Model/serial number plate
(located on the right-hand
side oven door trim)
D 30" (76.2 cm)
E. 27¼" (69.2 cm)
(271_ '' [70.3 cm] on
models KDRS807XSP
and KDSS907XSP) from
handle to standoff at
back of range**
F. 23" (58.4 cm) countertop
notch to rear of cooktop
*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm)
countertop; front of oven door protrudes 13/4 '' (4.4 cm)
(23/le'' [5.5 cm] on models KDRS807XSP and KDSS907XSP)
beyond 24" (61.0 cm) base cabinet.