KitchenAid KDRS807XSP00 Installation Instructions Manual page 22

9. Reinstall the cap onto the regulator.
!
E D C
A. Access cap D. Spring retainer
B. Gasket NAT position
C. Gas pressure regulator E. Spring retainer
LP position
To Convert Standard Surface Burners
1=
2.
3.
Remove burner cap.
Using a T20 TORX ®screwdriver, remove the burner base.
Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
5. Place LP gas orifice spuds in plastic parts bag for future use
and keep with the package containing literature.
6. Replace burner cap.
7. Repeat steps 1-6 for the remaining burners, except for the
TripleTier ® Flame burner (on some models). See "To Convert
TripleTier ® Flame Burners" section.
To Convert TripleTier _ Flame Burner (on some models)
1. Remove burner cap.
2. Remove the burner head using a size T20 TORX _ screwdriver.
3. Remove the plate on the external gas orifice spud.
B
4=
A. Igniter electrode
B. Gas tube opening
C. Burner cap
D. Burner base
Natural gas orifice spuds are stamped with a number on the
side. Replace the LP gas orifice spud with the correct Natural
gas orifice spud.
A. Stamped number
Refer to the following chart for the correct Natural gas orifice
spud placement.
Natural Gas Orifice Spud Chart for Standard Surface Burners
Burner Location Burner Rating Size
Right front 6,000 Btu/h 1.10 mm
Left front 14,000 Btu/h 1.70 mm
Right rear 12,500 Btu/h 1.61 mm
Left rear 6,000 Btu/h 1.10 mm
A. Burner caps
B. Burner heads
C. External gas orifice spud access plate
D. Internal gas orifice spud
IMPORTANT: The TripleTier ® Flame burner has 2 gas orifice
spuds. Be sure to change the external gas orifice spud
located under the plate.
A ......
........... /,
....................... ---- /o_ : , _
c ..................
=dTY
A. Plate
B. External gas orifice spud
C. Internal gas orifice spud
4. Apply masking tape to the end of a 7 mm nut driver to help
hold the internal gas orifice spud in the nut driver while
changing it. Press nut driver down onto the internal gas
orifice spud and remove by turning it counterclockwise and
lifting out. Set internal gas orifice spud aside.
5. Use a 7 mm combination wrench to remove the external
orifice spud. Turn counterclockwise remove. Set external gas
orifice spud aside.
22