ICP OLR105A12B Installation Instructions And Owner's Manual page 4

a. Turnoff mainwatersupplyintothe structure and
drainthe waterlinesif possible.Openfaucetsin
appropriate areas.
b. Have someonecheck the structurefrequently
during coldweather t omakesureit iswarmenough
to prevent p ipes fromfreezing.Suggest t heycalla
qualified s ervice agency, i frequired.
2.3) Installation regulation:
Installation MUST conform with local building codes or
in the absence of local codes, with the National
Electrical Code, ANSI/NFPA No.70-1990 or current
edition and Installation of Oil Equipment, NFPA No.31.
3) LOCATING THE FURNACE
CAUTION
Check carefully your furnace upon delivery for
any evidence of damage that may have
occurred during shipping and handling. Any
claims for damages or lost parts must be
made with the Transport Company.
3.1) Location:
Locate the furnace as closely as possible to the
chimney or vent terminal, providing ample clearance to
permit easy accessibility for cleaning the inside of the
furnace, the removal of filters, blower, motors, controls
and flue connections. The furnace may be installed on
a combustible floor.
Do not install furnace directly on carpeting, tile or other
combustible material.
The furnace must be installed level for safe quiet
operation.
CAUTION
Do NOT operate furnace in a corrosive
atmosphere containing chlorine, fluorine or
any other damaging chemicals. Refer to Part
1, section 5.2.
TABLE #1
Minimum Installation clearances from combustible materials (Chimney installation*)
" " NOUF160
Furnace 1"
Sides Supply plenum, warm air duct 1"
within 6 ft of furnace
Back Furnace 18"
Top Furnace casing or plenum 2"
Bottom Furnace - combustible floor 0"
Front Furnace 24"
* See Part 1 section 4.3 for Direct Vent application clearance.
OLR105 -OLF105. NOLF105
• OUF105 - NOUF105
1 "
1 "
1 "
1 "
0"
24"
4) VENTING
4.1) General:
The furnaces can be vented in several ways:
Chimney Vented:
Using the Beckett AFG or Riello 40-F burner, the
furnaces can be chimney vented with or without a
barometric damper. The unit will be operated at a
negative over fire draft and stack draft.
Poison carbon monoxide gas, fire and
explosion hazard.
Read and follow all instructions in this
section.