Minimizing The Warm-Up Time - Minolta EP1052 Manual

20
4. Turning ON and OFF, and Resetting the Copier

Minimizing the Warm-up Time

Instead of turning the copier OFF, it's a good idea to use the Energy Saver Mode.
This mode will minimize the time for the copier to complete the warm-up cycle
to about 20 sec.
The Energy Saver Mode is automatically activated a given period of time after the
copier has been used last. The initial is 15 min.
Useful Tip
The time for the copier to enter the Energy Saver Mode can be selected
from 1 to 120 min. by using User's Choice.
NOTE
The copier is shut down if the Auto Shut OFF function activates while the
copier is in the Energy Saver Mode.
Energy Saver
Panel Reset
1142O093CA
p.53
Entering The Energy Saver Mode
Press the Energy Saver Key on the
control panel.
All control panel Indicators go out,
except that the Start Key and the
Energy Saver Key which remain lit
green.
1142O093CA
Leaving the Energy Saver Mode
Press any Key on the control panel,
for instance, the Start Key.
This cancels the Energy Saver
Mode, and the copier will be ready
to make copies in about 20 seconds.
1139O2360A