Install The Ribbon Cartridge; Replace The Top Cover; Connect The Printer To The Computer - Star Micronics LC-10 User Manual

install the ribbon cartridge
The top side of the ribbon cartridge has a handle for turning the ribbon.
Turn this handle in the direction of the arrow to tighten the ribbon.
Next place the ribbon cartridge on the print head carriage, guiding the
ribbon between the print head and the platen. Press down firmly on the
cartridge until it snaps into place.
Figure
7-5. Installing the ribbon cartridge
Replace the top cover
Hold the cover upright and engage the tabs at the back. Then swing
the front edge down until the cover is closed.
Leave the cover closed during normal operation.
It keeps out dust and
dirt and reduces the printer's operating sounds. Open the cover only to
change the ribbon or make an adjustment.
Connect the printer to the computer
Connect the printer end of the interface cable to the connector socket
on the right side of the printer as shown in Figure l-6.
Make sure the computer is turned OFF, then connect the other end
of the cable to your computer as described in the computer manual.
5