Mita DP-2800 Instruction Handbook Manual page 164

Message
I/F occupied
Processing
PAR FIT A4
Processing
PAR 600 A4
Processing
PAR 300 A4
Corrective Action
The interface selected is currently being used.
The interface is secured while the interface name displayed in the message
display is flashing even if the printer is in the ready state. How long this takes
depends on the interface release timeout (FRPO J2) setting.
This message appears, and then the ATTENTION indicator lights, when an
attempt is made to select a secured interface from the control panel or when
an attempt is made to perform memory card operations while the interface
indicator is flashing.
Repeat operations after releasing the interface.
Compressed data is printed due to insufficient memory.
Compressed data is printed due to insufficient memory when FIT flashes in
the resolution indicator. The quality of printed data is reduced when this
occurs. FIT will continue flashing even after printing is finished. The
resolution indicator will automatically return to reading 600 dpi when any key is
pressed, when a timeout occurs, or when subsequent data is received.
Expand printer memory to avoid this error.
600 dpi processing cannot be performed due to insufficient memory.
When 300 flashes in the resolution indicator even though the printer was set to
600 dpi, the printer automatically set resolution to 300 dpi due to insufficient
memory and continued printing. The resolution indicator will automatically
return to reading 600 dpi when any key is pressed, when a timeout occurs, or
when subsequent data is received.
Expand printer memory to avoid this error.
Chapter 5 Troubleshooting
5-15