Mita DP-2800 Instruction Handbook Manual page 163

Indicators and Messages
5-14
Message
MEMORYCARD err ##
Press CONTINUE
>Read fonts ?
Failed
Corrective Action
05: There is no battery in the memory card. Replace the battery in the
memory card with a new one.
06: The memory card is write-protected. Cancel the write-protection of the
memory card.
07: The memory card requires formatting. Format the memory card from the
control panel.
09: The capacity of the memory card is insufficient. This error code appears
when an attempt is made to write more data on the memory card than
available memory. To halt the writing of data, first stop data transmissions
from the computer, and then the printer's CANCEL key. Press the FORM
FEED key if the message Waiting will appear in the message display. The
message display will return to reading Ready.
11: The memory card is full of data items. The number of data items which
can be written on the memory card is limited to 127. Pressing the CANCEL
key will restore the message Ready in the message display.
13: This is a logical error. Try substituting another flash memory card.
17: The flash memory card cannot be written due to insufficient printer
memory. Either delete unnecessary macros and/or fonts stored in the printer,
or expand the printer's available memory.
18: This is a write error. Try substituting another flash memory card.
(Error codes 11 through 17 apply only to flash memory cards.)
The font cannot be read due to insufficient memory.
A download font could not be loaded into printer memory due to insufficient
available printer memory. Either remove unnecessary download fonts and/or
macros or expand the printer's memory.
(Continued on next page)