Media Converter Switch Connectors - Axis Q6035-C User Manual

AXIS Q6035-C PTZ Dome Network Camera
Hardware Overview
1
Power connector (DC input)
2
Power connector (DC output)
3
Network connector (internal)
4
Network connector SFP (external) (2x)
5
Network connector RJ-45 (external) (2x)
6
Camera LED indicator
7
Network LED indicator (4x)
8
Power LED indicator
9
I/O connector (internal)
10 I/O connector (external)
11 Multi-connector cable

Media Converter Switch Connectors

For technical specifications, see page 55.
NOTICE
NOTICE NOTICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the switch shall be
shielded (STP) and intended for their specific use. Make sure that the switch is properly grounded. See Electromagnetic
Compatibility (EMC) for regulatory requirements.
Important
The media converter switch does not support hotswapping. Disconnect power from the switch before swapping cameras. An
attempt to hotswap could cause the switch to freeze, in which case it must be restarted.
Power connector (DC input) - 2-pin terminal block for power input.
Power connector (DC output) - Two 2-pin terminal block for power output (pin 4 is not used).
Network connector RJ-45 (external) - Two RJ-45 connectors (10/100Base-T) for network connectivity.
Network connector SFP (external) - Two SFP connectors (100Base-FX/1000Base-X) for network connectivity.
7