Media Converter Switch Connectors - Axis Q6042-C Installation Manual

AXIS Q604 Series
SD Card Slot
An SD card (not included) can be used for local recording with removable storage. For more
information, see Specifications on page 18.
NO NO NO TICE TICE TICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To
unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Note
For SD card recommendations see www.axis.com
Control Button
The control button is used for:
• Resetting the product to factory default settings. See page 34.
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic DNS
Service. For more information about these services, see the User Manual.
Power Button
Press and hold the power button to temporarily power the product when the dome cover is
removed. The power button is also used with the control button to reset the camera to factory
default settings. See page 34.

Media Converter Switch Connectors

For specifications, see page 18.
NO TICE TICE
NO NO TICE
The product shall be connected using a shielded network cable (STP) or an optical fiber
cable. All cables connecting the product to the network shall be intended for their
specific use. Make sure that the network devices are installed in accordance with
the manufacturer's instructions. For information about regulatory requirements, see
Electromagnetic Compatibility (EMC) on page 2 .
Important
The media converter switch does not support hotswapping. Disconnect power from the
switch before swapping cameras. An attempt to hotswap could cause the switch to freeze,
in which case it must be restarted.
Power connector (DC input) - 2-pin terminal block for power input.
Power connector (DC output) - Two 2-pin terminal block for power output (pin 4 is not used).
16