MAINTENANCE ON CHASSIS AND ENGINE
Ignition curve plug connection
Open the cover
Info
The designation of the fuses is located on the inside cover of the fuse
box
Remove the faulty fuse.
Specification
Fuse 1 - 10A - ignition, CDI controller, indicator lamps ON, N, R
Fuse 2 - 15A - high beam, low beam, parking light, tail light, brake light, high
beam indicator lamp
Fuse 3 - 10A - radiator fan
Fuse 4 - 10A - for auxiliary devices (permanent positive)
Fuse 5 - 10A - for auxiliary devices (plus switched on with ignition switch)
Fuse res. - 10A/15A - replacement fuses
Info
You can recognize a blown fuse by its broken filament
100090-10
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect
fuses.
Use only fuses with the prescribed amperage. Never by-pass or repair
fuses.
Insert new fuse of suitable specification.
Fuse (58011109110)
Fuse (58011109115)
Info
If the new fuse burns out, contact an authorized KTM workshop.
Tip
The spare fuses should always be present in the fuse box so that thez are
available if needed.
Close the cover of the fuse box.
Install the front cover. (
The plug-in connector
Possible states
•
Soft
The plug-in connector is connected for better driveability.
•
Performance
100105-10
of the fuse box
.
.
P. 62)
is located under the trim at the front on the frame tube.
The plug-in connector is disconnected for better performance.
60
.