Carburetor - Idle - KTM 525 XC ATV 2008 Owner's Manual

MAINTENANCE ON CHASSIS AND ENGINE

Carburetor - idle

Fill the coolant into the radiator
Coolant
With compen-
sating tank
Without com-
pensating tank
600120-10
Open the screw
emerges from the opening.
Specification
Remaining screws, chassis
Info
Ensure that the radiator is always filled with a sufficient amount of coolant.
600121-10
Open the screw
emerges from the opening.
Specification
Remaining screws, chassis
600122-10
Completely fill the radiator and close the radiator cap
600123-10
Top up the compensating tank to level
Install the front trim. (
Make a short test ride.
Check the coolant level. (
600125-10
The idle setting of the carburetor has a big influence on the starting behavior, stable
idling and the response to throttle opening. An engine with a correctly set idle speed is
easier to start than if the idle is set wrongly.
Info
The carburetor and its components are subject to increased wear caused by
engine vibration. Wear can result in malfunctioning.
If the idle speed is set significantly higher, the engine does not start. When the
electric starter button is activated, the electric starter turns over the engine, but
the engine does not start because there is no ignition spark.
600145-10
.
1.50 l (1.59 qt.) Coolant (
Coolant (mixed ready to use) (
1.30 l (1.37 qt.) Coolant (
Coolant (mixed ready to use) (
to bleed the cylinder head. Tighten the screw
M6
to bleed the radiator. Tighten the screw
M6
. Mount the cap
P. 63)
P. 68)
70
P. 95)
P. 95)
P. 95)
P. 95)
when coolant
10 Nm (7.4 lbf ft)
when coolant
10 Nm (7.4 lbf ft)
.
.