MAINTENANCE ON CHASSIS AND ENGINE
Removing the front trim
Installing the front trim
Removing the rear fender
Remove the front cover. (
Remove screws
Raise the front trim and disconnect the plug-in connectors from the head light and
the emergency OFF switch with the rip cord.
Remove the front trim.
100075-10
Check parts for damage and wear. Replace damaged or worn parts.
Connect the plug-in connectors of the head light and the emergency OFF switch
with the rip cord and position the front trim.
Mount all screws.
Fully tighten screws
Specification
Screw on fuel tank
Fully tighten screws
Specification
Remaining screws, chassis
Install the front cover. (
100076-10
Remove the seat (
P. 62)
.
.
M6
.
M6
P. 62)
P. 61)
63
6 Nm (4.4 lbf ft)
10 Nm (7.4 lbf ft)