Riding Instructions; Checks Before Putting Into Operation; Starting - KTM 525 XC ATV 2008 Owner's Manual

RIDING INSTRUCTIONS

Checks before putting into operation

Info
Make sure that the vehicle is in a perfect technical condition before use.
Info
In the interests of riding safety, make a habit of making a general check before you ride.
Check the engine oil level. (
Check the engine for oil loss.
Check the fuel supply.
Check the chain tension. (
Check the chain dirt accumulation. (
Check the tire condition. (
Checking the tire air pressure. (
Check the front brake fluid level. (
Check the rear brake fluid level. (
Check the front brake linings. (
Check the rear brake linings. (
Check brake system function.
Check that the rear hubs are tight.
Check that the footrests are tight.
Check the handlebar bridge bearing for excessive play.
Check the handlebar for smooth operation and play.
Check the coolant level. (
Check the cooling system for leakage.
Check that all operating elements are correctly adjusted and free to move.
Check that the electrical equipment is functioning properly.

Starting

Danger
Danger of poisoning Exhaust gases are poisonous and can result in unconsciousness and/or death.
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in a closed
space.
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
Always warm up the engine at low engine speeds.
Info
If the engine is unwilling to start, the cause can be old fuel in the float chamber. The flammable elements of the fuel evapo-
rate after a long time of standing.
If the float chamber is filled with fresh fuel, the engine starts immediately.
Press the starter for a maximum of 5 seconds. Wait for a least 5 seconds until trying again.
Conditions
Vehicle has not been operated:
Empty the carburetor float chamber.
Turn the handle of the fuel tap to the ON position. (Figure 100013-10
Fuel can flow from the tank to the carburetor.
Mount the vehicle.
Insert the clip into the emergency OFF switch and fasten the rip cord to the clothing of the rider. (Figure 100010-10
Press the ENG. STOP switch into the RUN position.
P. 72)
P. 45)
P. 45)
P. 57)
P. 57)
P. 48)
P. 52)
P. 49)
P. 54)
P. 68)
1 week
x
( P. 72)
P. 16)
20
P. 16)