Frothing Milk; Auto-Cappuccino Set; Preparing Hot Water - Krups ESPRESSERIA AUTOMATIC Manual

FALC DISP USA - 7220.qxp
We recommend that you use pasteurised 1 or 2% milk. The milk should be quite cold, ideally between
42° F and 50° F (6 and 10° C). After having used the steam or hot water functions, the nozzle may be
hot, and we recommend that you wait for a few moments before handling it.
Check that the steam
nozzle is correctly
fitted.
To remove any remaining
milk from the steam nozzle,
place a cup under the noz-
zle and press the " steam "
button .
To interrupt the steam function, just press any button.
If the nozzle is blocked, clean it out with the included needle.
The maximum duration for production of steam per cycle is limited to 2 minutes.
XS 6000 XS 4000
To prevent the milk drying on and in the auto-cappuccino accessory we strongly recommend that
you immediately:
- put clear water inside the jug and reinstall the different components
- launch a "steam" cycle
- clean all parts with a moist cloth.
You can also use our special XS 4000 liquid cleaner for milk systems.
To interrupt the hot water function, just press any button. If the nozzle is blocked, clean it out with the needle
included. The maximum amount of hot water per cycle is limited to 10 oz/300 ml.
4/12/07 18:49

FROTHING MILK

Fill a frothing pitcher
Press the "steam" button
one-third and immerse
and follow the
the nozzle in the milk.
instructions on the screen.
Run for at least 10
seconds, then again
press the button to
stop steam generation.
AUTO-CAPPUCCINO SET XS 6000 (SOLD SEPARATELY)
The auto-cappuccino accessory makes it easy to
prepare a cappuccino or a caffe latte. It is comprised
of a special nozzle with two-positions/markings and
a brushed stainless steel milk jug and tubes.
Just join the various components to each other
(photo on left) and put your cup or glass under the
autocappuccino nozzle.
Don't forget to clean all parts of this accessory
thoroughly (photo right).

PREPARING HOT WATER

While the screen displays the drink selection menu, press the "hot water" button
A message will invite you to place a cup under the steam nozzle. Again press the
"hot water" button to produce hot water.
Page 10
Once your milk is frothed
to your liking...,
You can remove the steam nozzle for thorough cleaning. Wash it
using a brush with water and a little non-abrasive dish soap.
Rinse and dry. Before re-fitting, make certain that the air inlet
holes are not clogged by milk residue. If necessary clean out the
holes with the needle included with the machine.
10
press the "steam" button
to stop the cycle. Cycle
does not stop immediately.
.