Preparing Hot Water; Preparing Steam; Frothing Milk - Krups Espresseria Automatic EA80 Series Manual

now prepared your appliance. The drink select menu will be displayed.
Put two cups under the coffee outlets. You can lower or raise the coffee outlets to suit the
size of your cups.- Fig. 17. Select your drink and confirm by clicking twice on the OK key.
A message will appear to tell you that you have chosen two cups.
The appliance will automatically sequence 2 complete coffee-making cycles.
While the screen displays the drink selection menu, press the "hot water" key
A message will invite you to place a container under the steam nozzle. Again press the "hot
to produce hot water - Fig. 14.
water" key
To interrupt the steam function, just press any key.
If the nozzle is blocked, clean it out with a fine needle.
The maximum amount of hot water per cycle is limited to 300 ml.
Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats
up liquids. As you need a higher temperature to produce steam than to make an espresso,
the appliance runs an additional pre-heating phase for steam.
While the screen displays the drink selection menu, press the "steam" key
screen will inform you that the appliance is being pre-heated. Once the pre-heating phase
has been completed, a message will ask you to place a container under the steam nozzle
- Fig. 5. Press the "steam" key
produced first and then steam will start. Use the same key to stop steam generation.
BE CAREFUL, BECAUSE THE CYCLE DOES NOT STOP IMMEDIATELY.

Frothing milk

We recommend that you use pasteurised or UHT milk that has been recently opened.
Do not use untreated milk. After the steam function has been used, the nozzle will be
hot, and we recommend that you wait for a few moments before handling it.
Check that the steam nozzle is correctly fitted - Fig. 19.
Pour the milk into your milk jug. Only half fill it. Immerse the nozzle in the milk - Fig. 20.
Press the "steam" key
Once your milk is frothy enough... - Fig. 21, again press the "steam"
cycle. Be careful, because the cycle does not stop immediately.
To remove any remaining milk from the steam nozzle, place a container under the nozzle
and press the "steam" key
again press the "steam" key
You can remove the steam nozzle for thorough cleaning. Wash it using a brush with water
and a little non-abrasive washing up liquid. Rinse and dry it - Fig. 22-23. Before re-fitting,
make certain that the air inlet holes are not clogged by milk residues. Clean out the holes
with a needle if necessary - Fig. 24.

PREPARING HOT WATER

PREPARING STEAM

again to start generating steam. A little water will be
and follow the instructions on the screen.
. Let the hot water escape for at least 10 seconds and then
to stop water.
.
- Fig. 18. A
key to stop the
19