Moving The Marker; Adjusting The Reference Level; Adjusting The Scale; Checking Limits - Wavetek MS1300 Operation Manual

Note
The channels that appear on this screen are the same ones that you
selected when you configured your tilt channels. (see SELECT
TILT CHANNELS).

MOVING THE MARKER

A vertical marker appears over the currently selected carrier. The
channel number, type and label appear in the upper right-hand
portion of the screen. The frequency and level of the selected
carrier can be seen directly beneath the graph. You can use the left
or right arrows to select the previous or next carrier.

ADJUSTING THE REFERENCE LEVEL

The reference level setting is displayed above the graph. This is
the level at the very top line. You can adjust the reference level
using the up and down arrows. When you press the SHIFT +
keys, your microStealth automatically sets the optimum reference
level for you.

ADJUSTING THE SCALE

The scale setting is displayed above the graph. You can adjust the
scale to provide the best view of the carrier levels by pressing the
soft key. A new set of soft keys appears. Use the
soft keys to increment and decrement the scale value. Press the
soft key when you have finished.

CHECKING LIMITS

You can verify that the carrier levels are within limits. First, you
need to tell microStealth which test point you are at. This deter-
mines which set of limits are used. Press the
sequence through the available test points. The test point that you
have selected is represented in the upper portion of the screen by
one of the following icons:
Subscriber Drop
Ground Block
Tap
User Defined
and
soft key to
47