Wavetek MS1300 Operation Manual page 18

Tip
You can tell when the backlight is on even in bright sunlight by
looking for the backlight indicator at the left-hand edge of the Title
Bar. The indicator means that the backlight is currently on and
will turn off automatically. The
light is on and will remain on continuously. If you see no indicator,
the backlight is off.
TIME
Sets the time for the internal real-time clock. The time is set,
displayed and printed in 24 hour format only (HH:MM:SS).
DATE FORMAT
You can specify the format in which the date is displayed and
printed. Select between the following formats:
DATE
Sets the date for the internal real-time clock. You can specify the
format in which the date is set, displayed and printed (see DATE
FORMAT).
PRINTER
Select the manufacturer of the printer that you will be using. A
printer with a serial interface is required. Set your printer configu-
ration as follows:
Important
The baud rate of both your microStealth and your printer must
match (see BAUD RATE).
18
MM/DD/YY
DD.MM.YY
YY.MM.DD
Baud Rate:
Date Bits:
Stop Bits:
Parity:
Flow Control:
indicator means that the back-
same as your microStealth
8
1
NONE
Xon/Xoff