Wavetek MS1300 Operation Manual page 25

Step 3
You can tell microStealth what frequency to stop searching
for channels. This will save time when building the plan.
The frequency you enter should be just above the highest
channel on your system. If you are not sure what the
frequency of your highest channel is, just use the default
value that appears in the edit box. If you have entered a
value, be sure to terminate your entry with the
Press the
Upon pressing the
system for active channels. A bar graph indicates the percentage of
the channels searched. After the plan has been built, press the
soft key to return to the Channel Plan Configuration screen.
EDIT CHANNEL PLAN
You can edit various parameters for each channel. Press the
key to edit the channels. A list of all the channels in the plan
appears.
A check mark appears in the left-hand column when the channel is
enabled. When you built the channel plan, MicroStealth automati-
cally enabled all the channels it found to be active on your system.
You may want to verify that all your channels have been correctly
enabled. Use the
highlighted in the list.
soft key to begin building the plan.
soft key, microStealth begins searching your
soft key to enable/disable the channel
key.
25