Table of Contents
Advertisement
Installation/Installing
the Receiver
99
AUDIO R (fight) and AUDIO L (left)
This is left and right channel audio signal from the receiver. If you are connecting
the
receiver to a monitor type of television, connect these to the audio inputs. You can also
connect there connectors
to the audio input of a stereo amplifier.
Wide BAND DATA
This 15 pin connector
is designed to be used in conjunction
with future technology:
such as high definition
TV.
DRD203RW
Figure 84 is the rear panel of the DRD203RW
receiver. Its connection
can be divided
in inputs and outputs. The following is a functional list of the jack panel connections:
INPUTS
PHONE
This jack connects the to the telephone cable. The DSS receiver uses a toll free number
to update the access card.
This update usually last a few seconds
and ensures
continuous
program service.
SATELLITE
IN
This is the 950 to 1450 MHz input from the LNB. Also carries the DC voltages from
the receiver to the LNB.
IN FROM ANT
Connect either a cable signal or an antenna to this connector.
OUTPUTS
OUT TO TV
The is the RF out (either channel 3 or 4) of the receiver. This RF can be one of two
signals. One signal, is RF signal applied to the IN FROM ANT connector. The other
signal is the output of the receiver. The TV/DSS button on the front of the receiver
determines which signal is present on the jack.
r
@ooooooooo oooo ooooooo
00000000001- , ,.
ooooo/
I
I
IN FROM ,_1"
_JACK
®®®
Figure 84, Rear Panel DRD203RW
Advertisement
Table of Contents
