Table of Contents
Advertisement
Installation/Mounting
the Dish
51
13. Check the tightness of all bolts and proceed to the Assembling
the Dish section.
Installing
a Spacer (Optional)
If the siding is too narrow for the mounting foot, a spacer must be installed.
The spacer
can be held in place by the lower two mounting bolts of the mounting foot. To do this,
use the following
steps.
1. Remove
the lag bolts from the lower outside holes of the mounting foot.
2. Insert the spacer under the mounting
foot and mark the location of the two outside
holes. If the space has not been previously sized, mark the size of the spacer using
the mounting
foot as a guide. Use these marks to trim the spacer to the correct size.
3. With a 1/4" drill bit, drill the two holes just marked.
4.
Slide the spacer under the mounting foot and reinstall the two lag screws in the
outside holes.
5. Once the spacer is installed, check tightness of all bolts and proceed to Assembling
the Dish Components
section.
Advertisement
Table of Contents
