Table of Contents
Advertisement
Installation/Mounting
the Dish
67
2.
Position the mounting
foot so that the center two holes align with the center of the
rafter.
3. Mark the two center holes (the mast may need to be repositioned
for marking of
the second hole).
4. Drill two 1/8" holes in the locations marked. Fill each hole with a small amount
of roof sealant.
5. Attach the mounting
foot to the roof with two 1/4" x 3" wood type screws and
washers.
6. With a 3/16" drill bit in the drill, drill four pilot holes in the outside holes of the
mounting
foot. Fill each hole with a small amount of roof sealant.
7. Insert four 5/16" x t-1/2" with washer into these holes.
8. With a roof type of sealant, seal the mounting foot to the roof. When applying the
sealant, seal the areas marked in figure 51.
9. With a 7/16" wrench and bubble level, level the mast with the adjustment on the
mounting foot.
SEALANT
SEAL ALL EDGES _
HOLES
Figure 51, Sealing Roof
Advertisement
Table of Contents
