Table of Contents
Advertisement
Installation/Aligning
the Dish 111
ALIGNMENT
TAPE
TICK
MARKS
Figure 95, Adjusting Azimuth with Alignment
Tape
.
Continue this sequence and stop at the signal strength display's largest number or
the longest bar display. If you turn the dish all the way to one direction without
locking on a good signal, move back to the starting point and repeat the same
process in the opposite direction. If you do not get a signal, see the troubleshooting
section of this manual.
6. Once the azimuth is aligned, fine tune the elevation. Start this by loosening the
elevation bolts.
7. While watching the television display, move the dish up or down three degrees at
a time. Once the elevation has been moved three degrees, wait for the "rotate"
display to appear before moving it again.
8. Continue this sequence until the largest number or the longest bar display appears
on the signal strength display.
Then, tighten the both the azimuth and elevation
bolts to secure the dish in position.
Advertisement
Table of Contents
