Installation
/ Dish Assembly
85
3. Connect
one end of the LNB cable to the grounding
block.
4. Route the cable from the ground block to the dish mounting foot. Leave enough
slack in the cable to form a 3" to 5" drip loop.
Also, leave enough cable to reach
the LNB from the mounting
foot (about 3 feet).
5.
Secure the cable with cable clips.
Do not forget to form the drip loop and secure
it with cable clips.
6. Install the ground conductor
on the ground terminal of the coax .ground block.
7.
Route the ground conductor
to the grounding electrode.
Remember
to secure the
cable to a wall or some surface to protect it.
8. Connect
the ground conductor
to the grounding electrode.
TO
DISH
CABLE
CLIPS
CONDUCTOR
GROUND
ELECTRODE
(GROUND ROD)
DRIP
LOOP
Figure 69, LNB Cable Installation