Check Operation Of Oven Broil Burner - Whirlpool YSF377PEGQ7 Installation Instructions Manual

A
B
If your oven has electronic control pads only:
1. Press the "BAKE" pad.
• The "BAKE" indicator will light.
• "350" will appear in the display.
2. Press the START/ENTER pad.
• The "PREHEAT" or "HEAT," and "ON" indicators will
appear.
• If the burner fails to light due to air remaining in the
gas line, reset the oven control by pressing the
"OFF/CANCEL" pad and then pressing the "BAKE"
and "START/ENTER" pads again to reactivate the
bake operation.
[] Check the oven burner for proper flame. The
flame should be 1/2" (13 mm) long, with inner
cone of bluish-green, and outer mantle of dark
blue, and should be clean and soft in character.
No yellow tips, blowing or lifting of flame should
occur, if burner does not light, check that the
regulator shutoff valve is in the "on" position
(see Step 11}.
if oven flame needs adjusting:
Locate the ah shutter next to the pressure regulator.
Loosen screw and adjust the air shutter until the proper
flame appears. Tighten screw.
[]Turn the control knob to "OFF" or press the
"OFF/CANCEL" pad.
[] Replace flame spreader, oven bottom and oven
racks.
Check operation of oven broil burner
mmmQ
C
[] Follow the instructionsfor your type of oven
controls.
Note: A faint ticking sound will be heard while the oven
burner lights. The oven burner should light within 8
seconds.
i!i!i!i!i!i!i!i!_ik!_!:_:i_!!:::::!i!i! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I! ¸I!I!I!I!I!I!I!I ¸I!I!I!I!I!I!I ¸I!I!I!I!I!:!
OVEN ON •
!TURN OFF OVEN WHEN FLASHING)
OVEN HEATING O
DOOR LOCKED/CLEANING •
_CLOSEDOORWHENFLASHING_
OFF PUSH TO
TURN
-!- =\:ARM
%_o._ jj)._o
................... ii_ e 300
500 / • I • \
450 400
Push in and turn the oven selector control knob to
"BROIL." If the burner fails to light due to air remaining
in the gas line, reset the oven control by turning selector
knob to "OFF" and then again to "BROIL".
Page 11