Whirlpool YSF377PEGQ7 Installation Instructions Manual page 9

Gas and electrical connections
All connections must be wrench-tightened.
Typical rigid pipe connection
/gO°elbow
[_ nipple
/ _] _ union manual
gas shut-
pressure off valve
regulator
pipe /
gO°elbow
Typical flexible connection
union nipple
\
1/2" to
3/4" gas
pipe
pressure use pipe-joint
regulator compound
manual
adapter gas shut-
off valve
flexible con-
Rector
adapter'S/ 1/2" to
/ 3/4" gas
use pipe-joint
compound pipe
A 1/2" male pipe thread is needed for connection to pressure regulator
female pipe threads.
[] Use 15/16" combination wrench and channel
lock pliers to attach the flexible connector to the adapters.
Check that connector is not kinked.
manual shutoff valve _
"open" position
[] Check that range regulator shutoff valve is in
the "on" position. Open the manual shutoff valve in the
gas supply line.
[]Apply pipe-joint compound made for use with L. R
gas to the smaller thread ends of the flexible connector
adapters. Attach one adapter to the pressure regulator
elbow and the other adapter to the gas shutoff valve.
Tighten both adapters.
[]Use a brush and liquid detergent to test all gas
connections. Bubbles around connections will indicate a
leak. If a leak appears, shut off gas valve controls and
tighten connections. Then check connections again.
Never test for gas leaks with a match or other flame.
Clean all detergent from range.
[] Center the burner cap on burner base.
Burner cap should be level when properly positioned.
Place burner grates over burner,
[] Plug power supply cord into grounded
electrical outlet.
Page 9