Electric range aqualift self-cleaning technology (20 pages)
Summary of Contents for Whirlpool YSF379LEMB0
Page 1
Moving the range children and adults. iiiiiiiiiiiiiiiii www.whirlpool.com iMPORTANT: Read and save these instructions. Write down the model and serial iMPORTANT: numbers before installing range. Installer: Leave Installation Both numbers are listed on the Instructions with the homeowner.
Page 2
Before you start... It is the customer's responsibility: Your safety and the safety WARNING: If the • To contact a qualified electrical installer. others are very important. information in this manual • To assure that the electrical installation We have provided many important safety is not followed...
Tools needed: Materials needed: Parts supplied: Assemble the required tools and parts • gas line shutoff valve before starting installation. Read and • 1/2" male pipe thread nipple for connection Not shown: follow the instructions provided with to pressure regulator literature pack tools listed...
Gas supply requirements Observe all governing codes and ordinances. connection: Rioidpipe This installation must conform with local Requires codes and ordinances. In the absence combination pipe fittings local codes, installations must conform with American National Standard, obtain an in-line connection to the range.
Product dimensions Grounded electrical outlet is required. See "Electrical requirements:' Proper gas supply connection must be available. See "Gas supply requirements:' i l: 27-1/8" (68.9 cm) J depth with handle 36" (91.4 cm) cooktop height 46-7/8" (119.1 era) overall height 25"...
Page 6
Now start... Contact a qualified floor covering installer for the best procedure [] Make sure the anti-tip bracket drilling mounting holes through your installed: type floor covering. Excessive Weight Hazard * Look for the anti-tip bracket securely Use two or more people to move attached...
Gas and electrical connections Use 5/16" combination wrench m Apply pipe-joint compound made [] Test all connections for use with LR gas to the smaller thread and channel lock pliers to attach brushing on an approved non-corrosive ends of the flexible connector adapters.
Check operation If flame needs to be adjusted, turn You can check the burner flame by Electronic ignition system control knob to the "LOW" setting removing the flame spreader or by using Cooktop and oven burners use electronic remove control knob.
Page 9
if your oven has electronic If oven flame needs to be adjusted: If your oven has electronic Locate the air shutter next to the controls: controls: pressure regulator. Loosen screw 1. Press the "BAKE" pad. 1. Press the "CUSTOM BROIL' pad. adjust the air shutter until...
Gas conversions L.R Gas Gas conversions (from Natural gas to hE _ressure regulator gas; or from gas to Natural gas) must Surface Propane rate Orifice Color be done by a qualified installer. burner (BTU/hr) Number Marking Left 8,000 Green/ rear Lt.
Page 11
[] Oven burner: Use 1/2" combination Reinstall the storage drawer. [] Surface burners: Remove burner caps. Use a Phillips or Quadrex wrench to loosen the orifice hood away Complete installation steps 9 through screwdriver to remove the two screws from pin (approximately 2 to 2-1/2 turns).
If range does not if you need assistance: If you need service: operate: if you have questions about operating, Maintain the quality built into your range cleaning or maintaining your range: by calling an authorized service Check that the circuit breaker is not company.
Need help?
Do you have a question about the YSF379LEMB0 and is the answer not in the manual?
Questions and answers