Hazard Warning Lamps; Cornering Light Function; High Beam Flasher - Mercedes-Benz CLA Operator's Manual

Press the combination switch beyond the
X
pressure point in the direction of
arrow :.
In the à position, the high-beam
headlamps are only switched on when it is
dark and the engine is running.
The blue K indicator lamp in the
instrument cluster lights up when the high-
beam headlamps are switched on.
To switch off the high-beam
X
headlamps: move the combination switch
back to its normal position.
The blue K indicator lamp in the
instrument cluster goes out.
i
Vehicles with Adaptive Highbeam Assist:
when Adaptive Highbeam Assist is active,
it controls activation of the high-beam
headlamps ( page 108).
Y
High-beam flasher
To switch on: turn the SmartKey in the
X
ignition lock to position 1 or 2 or start the
engine.
Pull the combination switch in the direction
X
of arrow =.

Hazard warning lamps

The hazard warning lamps automatically
switch on if:
an air bag is deployed
R
the vehicle decelerates rapidly from a
R
speed of more than 45mph (70 km/h) and
comes to a standstill
Exterior lighting
To switch on the hazard warning lamps:
X
press button :.
All turn signals flash. If you now switch on
a turn signal using the combination switch,
only the turn signal lamp on the
corresponding side of the vehicle will flash.
To switch off the hazard warning
X
lamps: press button :.
The hazard warning lamps switch off
automatically if the vehicle reaches a speed
of over 6mph (10km/h) again after a full
brake application.
i
The hazard warning lamps still operate if
the ignition is switched off.
Headlamp cleaning system
The headlamps are cleaned automatically if
the "Wipe with washer fluid" function is
operated five times while the lights are on and
the engine is running (
switch off the ignition, the automatic
headlamp cleaning system is reset and
counting is resumed from 0.

Cornering light function

The cornering light function improves the
illumination of the road over a wide angle in
the direction you are turning, enabling better
visibility in tight bends, for example. The
cornering light function can only be activated
when the low-beam headlamps are switched
on.
page 115). When you
Y
Z
107