Mercedes-Benz CLA Operator's Manual page 285

Checking and adding other service
products
Checking coolant level
G
WARNING
The engine cooling system is pressurized,
particularly when the engine is warm. When
opening the cap, you could be scalded by hot
coolant spraying out. There is a risk of injury.
Let the engine cool down before opening the
cap. Wear eye and hand protection when
opening the cap. Open the cap slowly half a
turn to allow pressure to escape.
! The coolant may only be checked and
corrected when the engine is cool (coolant
temperature below 104 ‡ (40 †).
Checking the coolant when the coolant
temperature is above 104 ‡ (40 †) may
result in damage to the engine or to the
engine cooling system.
Example
Park the vehicle on a level surface.
X
Only check the coolant level when the
vehicle is on a level surface and the engine
has cooled down.
Turn the SmartKey to position 2 in the
X
ignition lock ( page 137).
Y
Check the coolant temperature display in
X
the instrument cluster.
The coolant temperature must be below
104 ‡ (40 †).
Turn the SmartKey to position
X
0 ( page 137) in the ignition lock.
Y
Engine compartment
Slowly turn cap : half a turn counter-
X
clockwise to allow excess pressure to
escape.
Turn cap : further counter-clockwise and
X
remove it.
If the coolant is at the level of marker bar
= in the filler neck when cold, there is
enough coolant in coolant expansion
tank ;.
If necessary, add coolant that has been
X
tested and approved by Mercedes-Benz.
Replace cap : and turn it clockwise as far
X
as it will go.
For further information on coolant, see
( page 349).
Y
Adding washer fluid to the windshield
washer system/headlamp cleaning
system
G
WARNING
Windshield washer concentrate is highly
flammable. If it comes into contact with hot
engine components or the exhaust system it
could ignite. There is a risk of fire and injury.
Make sure that no windshield washer
concentrate is spilled next to the filler neck.
Example
To open: pull cap : upwards by the tab.
X
Add the premixed washer fluid.
X
To close: press cap : onto the filler neck
X
until it engages.
283
Z