Calling Up; Setting - Mercedes-Benz CLA Operator's Manual

Features
276
i
Make sure that you clear the memory of
the integrated garage door opener before
selling the vehicle.
Compass
Calling up the compass
The compass displays in which compass
direction the vehicle is currently traveling: N,
NE, E, SE, S, SW,
To receive a correct display in rear-view
mirror :, the compass must be calibrated
and the magnetic field zone set.
Setting the compass
Determine your position using the following
X
zone maps.
North America zone map
W or NW.
South America zone map
Push a round pen into opening
X
=( page 276) for approximately three
Y
seconds.
The zone currently selected appears in
compass display ;(
To select the zone: push a round pen into
X
opening =( page 276) until the desired
Y
zone is selected.
If, after a few seconds, the display in
compass display ;(
direction, the zone has been selected.
Calibrating the compass
Make sure that there is sufficient space for
X
you to drive in a circle without impeding
traffic.
In order to calibrate the compass correctly,
do the following:
calibrate the compass in the open and not
R
in the vicinity of steel structures or high-
voltage transmission lines.
switch off electrical consumers such as the
R
climate control, windshield wipers or rear
window defroster.
close all doors and the trunk lid.
R
Switch on the ignition.
X
Push a round pen into opening
X
=( page 276) for approximately six
Y
page 276).
Y
page 276) changes
Y