Table of Contents
Advertisement
Document 2131145. Rev 1.0 May.09
Cet appareil numérique respecte les limites de bruits radioélec‐
triques applicables aux appareils numériques de Classe B
prescrites dans la norme sur le matériel brouilleur: ʺAppareils
Numériquesʺ, NMB‐003 édictée par le ministre des Communi‐
cations.
If you have purchased this product under a United States
Government contract, it shall be subject to restrictions as set
forth in subparagraph (c)(1)(ii) of Defense Federal Acquisitions
Regulations (DFARs) Section 252.227‐7013 for Department of
Defense contracts, and as set forth in Federal Acquisitions
Regulations (FARs) Section 52.227‐19 for civilian agency
contracts or any successor regulations. If further government
regulations apply, it is your responsibility to ensure
compliance with such regulations.
Information pertaining to OEM customers
The AirCard 402 modem has been granted modular approval
for mobile applications. Integrators may use the AirCard 402
modem in their final products without additional FCC / IC
certification if they meet the following conditions. Otherwise,
additional FCC / IC approvals must be obtained.
1.
At least 20 cm separation distance between the antenna
and the user's body must be maintained at all times.
2.
To comply with FCC / IC regulations limiting both
maximum RF output power and human exposure to RF
radiation, the maximum antenna gain must not exceed
5.2 dBi in the Cellular band and 3.75 dBi in the PCS band.
3.
The AirCard 402 modem and its antenna must not be
colocated with any other transmitter or antenna within a
host device.
4.
A label must be affixed to the outside of the end product
into which the AirCard 402 modem is embedded, with a
statement similar to the following:
This device contains TX FCC ID:
This equipment contains equipment certified under IC:
2417C-AC402
.
A user manual with the end product must clearly indicate
5.
the operating requirements and conditions that must be
observed to ensure compliance with current FCC / IC RF
exposure guidelines.
6.
The end product with an embedded AirCard 402 modem
must pass the unintentional emission testing and properly
authorized per FCC Part 15 requirements.
Regulatory Information
N7NAC402
.
39
Advertisement
Table of Contents
