Parts Supplied; Cavity Preparation; Water Connection; Water Pressure - Fisher & Paykel DS605 Installation Instructions Manual

@
Drain hose
support (1)
PARTSSUPPUED
Drain hose Wire clip (2) Clamp (1) Phillips Washer(1) Moisture protection Edge Protector (1)
joiner (1) 16 mm tape (1) (if servicehole
screws(% pcTrtitionismetcT/)
Ifthe Drain hose(s)supplied are not long enough to reach your services,you must use a Drain HoseExtension Kit P/N 925798which will extend the drain hose(s)by 3.6m.The kit is available from the nearest Fisher& Paykel
Authorized ServiceAgent, or Toll free 1.888.936.7872 or www.flsherpaykekcom.
CAVITY PREPARATION
_F
..)e
lmportand
Besurethe edgesof the services hole are smoothor covered. I f the serviceshole isthrough a metal
partition the hole mustbeprotected with the EdgeProtectorsupplied toprevent damage to the
power cordor hoses.
These marks indicate mounting tab screw locations.
Note: Toalign drawer front to adjacent cabinetry, the product to countertop clearance can
be increased to 1/8"(3 ram).
Preferred position. If adequate clearance, services hole can be higher.
If hole is higher, ensure drain hose(s)are routed straight into the waste connection.
Water Connection
Recommended HOT (Maximum 140°F/60°C).
Supplied hose to suit 3/8" (9 mm) male compression fitting.
Water Pressure Max Min
Water softener models 1 MPa (145 psi) 0.1 MPa (14.5 psi)
Other models 1 MPa (145 psi) 0.03 MPa (4.3 psi)
Drains will need to be separated to satisfy kosher requirements. We suggest you confirm
acceptability with your local rabbi in respect to kosher installations.
Drain hose 79" 71 "
(2011 mm) (1794 mm)
Inlet hose 37" 53"
(1551 ram) (1344 mm)
Power cord 51" 28"
(935 mm) (719 mm)
Left hand
side
Right hand
side
max. o 1 1/2"(38 mm)
Note: Services can be located
• , _de of DishDrawer®"
.... I
max. 17 1¼6"
_(450 mm) i
Adjacent cabinetrymust not
extend above cadty base
min.
7 z/8"
i(200 mm)
L_
L 110-120 VAC
max. 15 A