EdilKamin Iris Plus Installation & Operation Manual page 13

Weekly Timer Program built into the Little Control Panel
Weekly time programmer built into panel
Using the weekly time programmer built into the central panel
it is possible to set 3 ignition programmes:
• Pr01 with settable on and off times;
• Pr02 with settable on and off times;
• Pr03 with settable on and off times.
One or more of the three programs can be enabled for
each day of the week (day1=Monday;day2=Tuesday...
day7=Sunday).
When on standby the display alternates between displaying
the ignition mode (P1, P2 or P3 or a temperature) and the
current time.
Refer to page 12 for each of the buttons to be pressed.
Setting the clock
1. Hold the MENU key down for about two seconds until IP
appears then release, tS appears.
2. Press (-) and "Prog" will appear.
3. Press "Menu" and "ProF" will appear. Press the (-) key
and "SEt" will be displayed.
4. Confirm with the "Menu" key, which will display
HOUR:MIN, values can then be varied with the (-)
and (+) keys.
5. Once the hour has been set, confirm with "Menu" and the
day number will appear (day 1=Monday, day2=Tuesday...
day7=Sunday) which can be varied with the (-) and (+)
keys.
6. Confirm with "Menu" and "Prog" will appear.
7. Press "ON/OFF" to exit from setting.
Enabling programmes
1. Hold the MENU key down for about two seconds until IP
appears then release, tS appears.
2. Press (-) and "Prog" will appear.
3. Press "Menu" and "ProF" will appear.
Note: PrON will be displayed if programming has previously been enabled.
If so you can exit thie section by pressing O/1 and proceed to setting
program section.
4. Confirm by pressing the "Menu" key, pass now to "on"
with the (-) or (+) keys.
5. Confirm with the "Menu" key and "Prog" will appear.
Press "ON/OFF" to exit from setting.
6. The pellet fire is now in "PrOn" mode and will accept
timed on and off commands.
Setting a program (e.g. Pr01)
1. Hold the MENU key down for about two seconds until IP
appears then release, tS appears.
2. Press (-) and "Prog" will appear.
3. Press "Menu" and "ProF" or "PrOn" will appear. Press (+)
until "Pr 1" appears (after PrOn has been set previously).
4. Confirm with the "Menu" key and OnP1 will appear and
then the desired set hour for programme 1 ignition.
5. The time can be changed using the On/off (-) or (+) keys.
6. Press the "MENU" key to confirm.
7. OFd1 appears (indicating that program 1 is not enabled
for day1, continue to go through the days, disabling/
enabling as required).
8. Press (+) to enable it, after which Ond1 appears,
indicating that program 1 is enabled for Monday.
9. Press the "MENU" key to move on to the second day,
Tuesday, and so on until day7.
10. Press the "On/off" to exit.
11. Pr02 and Pr03 on and off times and the days on which
they are enabled can be set in a similar way.
12. A small green bar will light-up in the bottom right corner of
the control panel when a program is enabled for that day.
Note: You can override the pre-programmed settings if need be.
Note: Automatic cleaning .. every 20 minutes the combustion fan will
speed up for 10 seconds to blow excess ash from the burn pot.
PAGE 13