Fitting The Seat Forward Facing; Option A - Standard Routing - Britax First Class Si User Manual

Fitting the Seat Forward Facing. Standard Routing 'A'
CHECK THAT: YOUR CHILD WEIGHS MORE THAN 9KG.
YOUR CHILD IS ABLE TO SIT UNAIDED.
From 13kg you must ONLY install the First Class Si forward
facing using a lap-and-diagonal seat-belt.
IMPORTANT – You must adjust the length of the crotch strap as shown in 'Removing the newborn
insert' on page 14
Installing with a lap and diagonal seat-belt
IMPORTANT
adjust the height of the harness BEFORE installing the First Class Si in your car. It cannot be
adjusted whilst the seat is installed.
IMPORTANT – Ensure that the recline foot is in the stowed position before attempting to install the
First Class Si forward facing. See the section 'To stow the recline foot' on page 13
IMPORTANT – The newborn insert MUST NOT be used when the First Class Si is installed forward facing.
1
Place the First Class Si forward facing on the car
seat then recline it fully by lifting the recline handle
(under the front of the seat shell) and sliding the
seat shell into the most reclined position.
3
Fasten the seat-belt, making sure that the seat-belt
is not twisted and that it lies in the area of the base
indicated by the red routing label, as shown.
IMPORTANT –
ONLY USE the one FURTHEST away from the seat-belt buckle.
– Have you adjusted the harness to the correct height for your child? You must
The First Class Si has two red Seat-belt locks.
2
Pass the seat-belt between the seat base and seat
shell, as shown.
4
Thread the diagonal section of the seat-belt
through the red seat-belt lock. Make sure you pull
the seat-belt in the direction of the arrow.
- 16 -
Option
A