Removing And Cleaning The Buckle - Britax First Class Si User Manual

Removing and cleaning the buckle

IMPORTANT –
Class Si harness. This can stop it from working as well as it should and so the
buckle may need cleaning from time to time.
Follow the instructions below if you do not hear a click when fastening the buckle.
1
First place the First Class Si in full recline. Then
loosen the harness (see 'Adjusting the harness'
on page 5) and lay the First Class Si on its
back. With both hands under the seat shell use
your finger tips to rotate the tab and push
it up through the slot in the seat shell and
cover.
3
Latch and unlatch the tongues into the harness
buckle several times until a strong click is
heard. If you still cannot hear a strong click run
it under warm water to rinse it again.
IMPORTANT –
oil any part of the harness buckle
Food and drink may find their way inside the buckle of the First
NEVER lubricate or
2
Clean the harness buckle with warm water.
Rinse thoroughly.
4
To re-fit the harness buckle to your car seat
hold the tab sideways and insert it into the slot
in the seat shell. Make sure the red harness
buckle button faces away from the seat. lf the
buckle still does not return to its original
working order, contact our Customer Services
Helpline on 01264 386034.Ensure that you
adjust the length of the crotch strap correctly.
When using the Newborn Insert, one metal
tab should be visable (longer strap). If the
Newborn Insert is not being used, the metal
tab should NOT be visable (shorter strap). See
'Removing the Newborn Insert' on page 14.
- 24 -