Changing The Oil Filter - HUSABERG "05 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

CHANGING THE OIL FILTER

Place a suitable vessel under the engine to allow the oil to drain.
Remove both screws (1) and screw an M6 screw in the center hole (2)
of the oil filter cover.
1
NOTE: only tighten the screw by hand, otherwise you will
damage the oil filter cover.
3
Pull the oil filter cover (3) out of the hole with the screw M6 and remove
the screw.
2
1
Use pliers to pull the oil filter element (4) from the housing.
Clean the oil filter cover, the sealing areas on the O-rings and the engine
case. check the O-rings (5) in the
oil filter cover for damage and replace if necessary.
4
Lay the motorcycle down and fill the oil filter housing approx. half-full with
engine oil. Insert the oil filter in the housing.
Grease the O-rings in the oil filter cover and mount the cover. Mount the
screws and tighten to 6 Nm.
Place the motorcycle in an upright position again.
5
5
Unscrew the oil filler plug (6) and add 1 liter of fully synthetic engine oil
(e.g.: Motorex Power Synt. 4T).
Start the engine and check all of the plugs and the oil filter cover for
6
leakage.
Finally, check the engine oil level and correct if necessary.
- 55 -