Activating And Deactivating Display Modes - HUSABERG "05 Owner's Manual

ACTIVATING AND DEACTIVATING DISPLAY MODES

In the display mode SPEED/H, press and hold the
to access the SETUP menu. The active functions will be displayed. The
blinking function can be activated by pressing the + button and deacti-
vated by pressing the – button.
Press and hold the button 3 seconds to store the settings.
If no button is pressed for 20 seconds, the setting will be stored automa-
tically and the display will return to the SPEED/H mode.
+ button activates the blinking display
– button deactivates the blinking display
briefly press button changes to the next display without changing
any settings
hold button 3 secs. starts the SETUP
stores the settings and changes to the SPEED/H
mode
The following display modes can be activated:
TR1 tripmaster 1
TR2 tripmaster 2
A1 average speed 1
A2 average speed 2
S1 stop watch 1
S2 stop watch 2
CLK clock
LAP lap time
MAX maximum speed
KMH/MPH display in kilometers or miles (see: Kilometers or miles)
If you have activated all of the display modes, they will be displayed in
the following order:
SPEED/H, SPEED/CLK, SPEED/LAP, LAP/LAP, SPEED/MAX,
SPEED/ODO, SPEED/TR1, SPEED/TR2, SPEED/A1, SPEED/A2,
SPEED/S1, SPEED/S2
SPEED / CLK (TIME) DISPLAY MODE
CLK displays the time in hours, minutes and seconds.
+ button no function
– button no function
briefly press button changes to the next display mode
hold button 3 secs. set the clock menu
To set the clock, see „Setting the clock".
SPEED / LAP (LAP TIME) DISPLAY MODE
You can use the manual stop watch to stop and store up to 10 lap times,
which you can view in the LAP/LAP display mode (see below).
LAP displays the lap times in hours, minutes and seconds.
+ button Starts and stops the stop watch, lap time is not
reset to 0
– button Stops the stop watch, stores the lap time and
restarts the stop watch again. The time is reset
to 0. A total of 10 lap times can be stored. If the
lap time continues to run after you press the -
button, all 10 memory locations are occupied.To
clear all of the stored lap times, hold the
ton for 3 seconds in the SPEED/LAP mode.Up
to 10 lap times can be stored in this way.
briefly press button Changes to the next display mode.If no lap time
is stored or the motorcycle is driving, the
LAP/LAP mode will be skipped.
hold button 3 secs. Clears all LAP figures
OPERATION INSTRUMENTS
button for 3 seconds
but
- 10 -