Fuse (Fe/Fs); Replacing Headlight Lamp/Parking Light Lamp - HUSABERG "05 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

FUSE (FE/FS)

The fuse (1) is located in the electric starter relay (2) above the battery.
The fuse can be seen after removing the protection cover (A).
The following loads are connected to it:
– E-starter system
– Horn
– Speedometer
– Flasher light
The starter relay also contains a (10 amp) spare fuse (3).
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been installed gets blown again, you are strongly advised to have it
inspected by a Husaberg dealer.
The fuse capacity is 10 Ampere.
CAUTION: Under no circumstances is a stronger fuse allo-
wed to be installed or a fuse allowed to be "repaired". An impro-
per treatment could damage the whole electrical installation.

REPLACING HEADLIGHT LAMP/PARKING LIGHT LAMP

Loosen both rubber bands and tilt headlight mask to the front. Pull the
parking light lamp with holder (4) carefully out of the reflector. Pull con-
nector (5) off the headlamp and remove rubber cap (6). Disengage retai-
ning clip and take bulb out of reflector. When changing the parking-light
lamp, simply pull it out of the holder.
Insert the new lamp such that the noses (7) engage in the recesses (8).
When doing so, do not touch the glass body of the lamp so that it remains
free from fat. Engage retaining clip, mount rubber cap and connector. If
the parking-light lamp is to be replaced, simply insert it in the holder. Rein-
sert the parking-light lamp together with the holder.
Engage the bottom end of the headlamp mask at the retaining pins and
fix the mask by means of the rubber bands.
A
6
- 47 -
2
1
3
5
8
4
7