Fuse (Fe/Fs); Replacing Headlight Lamp/Parking Light Lamp - HUSABERG Edition 2004 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

FUSE (FE/FS)

The fuse (1) is located in the electric starter relay (2) above the bat-
tery.
The fuse can be seen after removing the protection cover (A).
The following loads are connected to it:
– E-starter system
– Horn
– Speedometer
– Flasher light
The starter relay also contains a (10 amp) spare fuse (3)
Replace a blown fuse only with an equivalent one. If a new fuse
that has just been installed gets blown again, you are strongly advi-
sed to have it inspected by a Husaberg dealer.
The fuse capacity is 10 Ampere.
CAUTION: Under no circumstances is a stronger fuse allo-
wed to be installed or a fuse allowed to be "repaired".
An improper treatment could damage the whole electri-
cal installation.
REPLACING HEADLIGHT LAMP/PARKING LIGHT
LAMP
Loosen both rubber bands and tilt headlight mask to the front. Pull
the parking light lamp with holder (4) carefully out of the reflector.
Pull connector (5) off the headlamp and remove rubber cap (6).
Disengage retaining clip and take bulb out of reflector. When chan-
ging the parking-light lamp, simply pull it out of the holder.
Insert the new lamp such that the noses (7) engage in the recesses (8).
When doing so, do not touch the glass body of the lamp so that it
remains free from fat. Engage retaining clip, mount rubber cap and
connector. If the parking-light lamp is to be replaced, simply insert
it in the holder. Reinsert the parking-light lamp together with the
holder.
Engage the bottom end of the headlamp mask at the retaining pins
and fix the mask by means of the rubber bands.
.
6
- 47 -
A
2
1
3
5
8
4
7