Alarm Connections - VCS VIP 10 User Manual

Configuring the Receiver Chapter 7
Enter a designation for the alarm input in the Name field. This name will be shown
on the transmitter's Livepage next to the associated alarm icon.
Alarm input 2:
Select On if the alarm is to be activated by the external alarm sensor 2.
Furthermore, you can choose whether the alarm is to be activated by an Active
high or Active low voltage signal.
Enter a designation for the alarm input in the Name field. This name will be shown
on the transmitter's Livepage next to the associated alarm icon.

Alarm connections

The VIP can be configured to connect to a specified remote location, such as a
transmitter, when an alarm is triggered.
Connect on alarm:
Select On, to establish a connection automatically to a specified IP address in the
event of an alarm.
With the setting Follows input 1, the VIP establishes an automatic connection to
a remote location as long as a signal is present at the alarm input 1. This setting
can also be used to connect two VIP units via a control switch. In this case, a
computer is not needed to establish the connection.
72 VIP 10 / VIP 1000