Video Input Settings; Audio Configuration - VCS VIP 10 User Manual

Configuring the Transmitter
QCIF 176 × 144 pixels
CIF 352 × 288 pixels
2CIF 704 × 288 pixels
Reset this parameter preset:
Click the Default button to reset the profile to its factory presets.

Video input settings

The 75 Ohm termination of the VIP can be set here. If the video signal is to be
looped through, the termination must be set off. The default setting for the video
input termination is On.
Video input termination:
To loop the video signal through choose Off.

Audio configuration

In addition to video data, the unit can also transmit audio signals. The
transmission of audio takes place at the same time as that of the video data and
thus increases the size of the data stream. If you use the MPEG-4 format for
video data, audio transmission can be activated separately here. In this case, the
audio data stream requires an additional bandwidth of about 80 kBit/s.
46
Chapter 6
VIP 10 / VIP 1000