Function Test - VCS VIP 10 User Manual

Configuring the Transmitter
– Enter the full path of the file to upload or click Durchsuchen... to select the
desired file.
– Make sure that the file to load is of the same type as the unit you want to
reconfigure.
– Click Upload to start transmitting the file to the unit.
This message will appear: Configuration upload finished. State:
Configuration upload ok (the system must be rebooted), and the
countdown for reconnection will be displayed.
– Restart the unit.
The next time the software update page is opened, the message Configuration
upload ok confirms the successful completion of the upload. If the message
Configuration upload failed is displayed, the file did not upload correctly.
Repeat the upload in this case, possibly with a different file.

Function test

The VIP offers a variety of configuration options. Therefore you should check that
it works properly after installation and configuration. Only in this way can you
ensure that the VIP will also function properly in an alarm situation.
Check for the following (among other things):
the VIP can be contacted remotely,
the VIP transmits all the required data,
the VIP responds as configured to alarm events and
that any peripheral devices respond properly to control signals.
66
Chapter 6
VIP 10 / VIP 1000