UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
UNPACKING:
Your MK-2005G has been shipped from the factory thoroughly inspected. Only minimal assembly is required.
If not done, completely remove the plastic wrapping from the MK-2005G.
Remove the accessories box from the Water Basin and remove the contents from the box.
CONTENTS:
In your container, you will find one (1) MK-2005G, one (1) movable cutting table, one (1) adjustable cutting
guide, one (1) drain plug, one (1) blade wrench, one (1) owner's manual, one (1) Honda owner's manual and
one (1) warranty card.
MK-2005G
Owner's Manual
TRANSPORT:
The MK-2005G weighs approximately 200 pounds; two people should be used when transporting the saw.
1. Never transport the MK-2005G with water in the Cooling Basin.
2. The MK-2005G, Brick Saw weighs approximately 200 pounds; two people are required when
lifting or moving.
NOTE: Lock the Cutting Head in the DOWN position, and remove the Movable Cutting Table when
transporting the MK-2005G.
The MK-2005G is designed with recessed handles in the right and left upright castings for ease of transport.
To transport –
•
Verify the Movable Cutting Head is locked in the down position and the Movable Cutting Table is removed
•
Grasp the saw by the recessed handle in the right and left upright castings
•
Grasp the front of the saw
•
Lift and transport the saw to the desired work location
Remove Movable
Cutting Table
Lift Point
MK-2005G
Movable
Cutting Table
Honda
Owner's Manual
Revision 04/2003, Effective Date April 2, 2003
Adjustable
Cutting Guide
Warranty
Card
Drain Plug
Cutting Head
Locked Down
Lift Point
Blade
Wrench
Page 9