Assembly - MK Diamond Products MK- 2005G Owner's Manual & Operating Instructions

UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY

ASSEMBLY:

Follow the assembly instructions in this section to prepare your MK-2005G for operation.
1. Movable Cutting Table Installation:
Cutting Table
Front
Roller Wheels
(A)
Position Movable Cutting
Table Roller Wheels
above Saw Guide Rails
2. Adjustable Cutting Guide Installation:
NOTE: The Adjustable Cutting Guide can be used on either side of the Diamond Blade.
Turn counter-
clockwise to loosen
(A)
Loosen Adjustable Cutting
Guide retaining thumbscrew
3. Releasing Cutting Head:
The following actions will cause the Cutting Head to rotate upward, hold the saw by the handle and
control the upward movement.
NOTE: The Cutting Head is locked in the down position when shipped from the factory.
Locking Handle
9/16-inch wrench
(A)
Remove Cutting Head Locking
Handle from shipping location
discard the Shipping Nut
MK-2005G
Guide Rail Roller Wheels
Seat Movable Cutting Table
Roller Wheels on Saw
Position Adjustable Cutting
Guide above Movable
Turn counter-
clockwise to
loosen
Shipping Bolt
Remove Shipping Bolt from
the Cutting Head – discard
Revision 12/00, Effective Date December 26, 2000
Guide Rails
(B)
Guide Rails
Align
Parallel Slots
Ruler/Stop
(B)
Cutting Table
9/16-inch
wrench
(B)
Shipping Bolt
Move back and forth to
verify ease of movement
(C)
Verify Movable Cutting Table
is seated correctly
Turn clockwise
to tighten
(C)
Seat and tighten the
Adjustable Cutting Guide
retaining thumbscrew
Turn clockwise
to tighten
Height
Adjustment
Locking Handle
Stud
(C)
Install Cutting Head
Locking Handle into
Height Adjustment Stud
Seated
Page 11