Unpacking, Transport, Stand And Assembly; Unpacking; Contents; Transport - MK Diamond Products MK-370 EXP Owner's Manual & Operating Instructions

UNPACKING, TRANSPORT, STAND and ASSEMBLY

UNPACKING

The MK-370 EXP is not designed to cut plastic or ferrous (metals) material.
CAUTION
!
Use proper lifting techniques when lifting the MK-370 EXP
If not done, remove the MK-370 EXP, accessory box from the carton.

CONTENTS

In your container, you will find
One (1) MK-370 cutting surface and water pan,
One (1) MK-370 cutting head,
One (1) 7-inch wet cutting continuous rim blade,
One (1) splash guard,
One (1) splash guard washer,
MK-370 EXP
Cutting Surface
Splash Guard
Wing Nut
Blade Nut
Wrench

TRANSPORT:

1. The MK-370 EXP weighs approximately forty-six (46) pounds; use care when transporting.
CAUTION
!
2. Never transport the MK-370 EXP with water in the Water Pan.
The MK-370 EXP is designed with a rigid frame and removable Cutting Head making the saw easily
transportable. To lift the saw, grasp the front and back of the frame at the lift points shown below.
Lift Point
12
MK-370 EXP Diamond Blade
Cutting Head
Electric
Water Pump Discharge Fitting
Inner Flange
Wrench
Revision 12/03, Effective Date December 30, 2003
One (1) splash guard wing nut,
One (1) electric water pump,
One (1) pump discharge fitting,
One (1) cooling transfer tube
One (1) Flow adjusting Clamp
Splash Guard
Pump
Transfer Tube
Owners
Manual
One (1) blade wrench
One (1) shaft wrench,
One (1) owners manual,
One (1) pump manual and
One (1) warranty card.
Splash Guard
Washer
Cooling
Adjusting Clamp
Pump Warranty
Manual
Cutting
Head
Lift Point
Flow
Card
MK-370 EXP