MK Diamond Products MK- 2005G Owner's Manual & Operating Instructions page 17

SETUP, STARTUP, ADJUSTMENT, OPERATION and SHUTDOWN
Clean Water
(D)
Fill the Water Basin
with clean water
III. Dry Blade Operation:
NOTE: Failure to perform the following steps will lead to premature pump failure.
Pivot Plate
(A)
Identify Water Pump Drive
End Pivot Plate
Splash Curtain
Curtain Rod
(D)
Remove the Splash Curtain
Slide Water Basin
out back Of Saw
(G)
Remove Water Basin
MK-2005G
(B)
Loosen Water Pump Drive End
Pivot Plate front and rear
retaining bolts
Loosen Wing Nut
Remove Water Pump
(E)
Loosen and remove Water
Pump adjustment clamp,
wing nut and bolt
Revision 12/00, Effective Date December 26, 2000
9/16-inch
Wrench
Pivot Up
Retaining Bolts
Pivot front of Water Pump Drive
End Pivot Plate up and tighten
Move Water Pump Assembly
9/16-inch
Wrench
(C)
the retaining bolts
Water Pump
(F)
to the outside of the
Water Basin
Page 17