Troubleshooting; Blade Will Not Cut Properly - MK Diamond Products MK- 2005G Owner's Manual & Operating Instructions

MAINTENANCE AND TROUBLESHOOTING

TROUBLESHOOTING:

Turn the ON/OFF switch to the OFF position and place the Fuel Valve in the CLOSED position
before performing the following.

1. Blade Will Not Cut Properly:

If "Glazed," Dress If not "Glazed,
(See Blade Dressing) go to Step B
(A)
Check for Smoothness
or "Glazing"
Contact Place of Purchase or
MK Diamond (800 421-5830)
To Verify Blade
Correct, go
(D)
Verify Blade Correct for
Material Being Used
2. Movable Cutting Table Does Not Move Correctly:
(A)
Check that the Guide
Rails are clean and
clean if dirty
MK-2005G
Check for Proper Rotation
If Blade
to Step E
Return to MK Diamond
Guide Rail
Check the Movable Cutting Table
Roller Wheels and replace if
Revision 12/00, Effective Date December 26, 2000
If Rotation
Correct, go
to Step C
Rotation Direction
(B)
Return to
MK Diamond
for Repair
(E)
Roller Wheels
(B)
necessary
If Core Not
If Core Bent, Bent, go to
Change Blade
(C)
Ensure Blade
Core Not Bent
Return to
MK Diamond
for Repair
(E)
Return to MK Diamond
Step D
Page 45