MK Diamond Products MK- 2005G Owner's Manual & Operating Instructions page 32

MAINTENANCE AND TROUBLESHOOTING
9. Movable Cutting Table Wheel Change Out:
NOTE: All four (4) Movable Cutting Table, Roller Wheels should be replaced at the same time (MK Diamond
Part No. – 133090)
Movable
Cutting Table
(A)
Remove the Movable
Cutting Table
Clean Holes
(D)
Prepare for Installation
Of New Roller Wheels
Lubricate with
Light Oil (WD-40,
3 in 1, etc)
(F)
Lubricate Roller Wheels
MK-2005G
Roller Wheels
(B)
Place Movable Cutting
Table On Work Bench
with Roller Wheels Up
Washer
(E)
Install Wheel/Washer Assembly
Into Movable Cutting Table
(H)
Install the Movable
Cutting Table
Revision 12/00, Effective Date December 26, 2000
1/2-Inch Wrench
Remove Roller Wheels
1/2-Inch Wrench
Roller Wheel
Retaining Nut – Tighten
Movable
Cutting Table
Rotate Wrench
Counter-clockwise
(C)
Rotate Wrench
Counter-clockwise
(G)
Install Roller Wheel
Page 32